Dynagear offers range of power transmission components like flexible coupling with clamplock spine locking, hydraulic motor overhung load adaptors, LPTO, tractor hydraulic pump PTO drives, splined components for hydraulics and mobile equipment, clamplock driveline companion flanges and yokes, single pump drives for diesel engines, right angle bevel drives, replacement parts for mobile equipment and contract machined components, right angle bevel drives, mini shaft to shaft couplings, cooling elements (add on or replacement) and dog clutches.
OEM Dynamics provides multiple hydraulic pump drives like TechnoDrive and Durst multiple hydraulic pump drives. OEM Dynamics’ Dynacool brand offers a range of products which includes, air cooled oil coolers like aluminium air- oil coolers, steel air – oil coolers, hydraulic motor driven fans, oil coolers with coaxial pump, Versacool oil coolers 12 & 24 volt, mobile 12 & 24 Volt DC motor fans and tower type air cooled oil heat exchangers for huge oil cooling.
CAST IRON CASES – Unlike our competitors, we utilise cast iron gear case construction. Cast iron expansion at the high temperatures encountered with this application is near equal to the expansion of the bearings and the outer bearing rings are retained in the case. Aluminium cases with high heat expansion often fail due to the outer bearing ring spinning and displacing particles of aluminium which destroy the bearings.
MODEL T33 – These models embody over 20 years of engineering experience with PTO pump drives. They were developed for use as directly driven hydraulic pump speed increasers for 540 or 1000 RPM tractor PTO shafts. Models for 540 RPM PTO’s are provided with a 1 3/8″ 6T spline hollow shaft and for 1000 RPM PTO’s, a 1 3/8″ 21T spline hollow shaft. Shafts are splined internally for full length for through drive. Normal practice is to utilise a torque arm to restrain the drive from rotation.
Maximum power is 50 horsepower with the 1:3.31 ratio models at 540 RPM input and 65 Horsepower in the 2.04 ratio models at 1000 RPM input. The T33 is available to accept most SAE “A”, SAE “B” or SAE “C” hydraulic pumps. Pump adaptors on the T33 may be changed in the field.
MODEL T33I – This model was developed for use as an implement mounted hydraulic pump speed increaser for 1000 or 540 rpm tractor PTOs where thrust loads from PTO shafts are encountered. Tapped mounting holes are provided or a factory fitted base mounting bracket can be supplied.
Maximum power is 50 horsepower with the 1:3.31 ratio models at 540 rpm input and 65 Horsepower with the 1:2.04 ratio models at 1000 rpm input. The T33I male shaft input model is available to accept most SAE “A”, SAE “B” or SAE “C” hydraulic pumps. Pump adaptors on the T33I may be changed in the field. The T33I male shaft input & output model is supplied with a 1 1/2″ x 3/8″ keyed output shaft.